JOAP: SIB - General Catalogue - 2020

17 Cable glands WADI-BN TYPE 1 - 6BIS IP68 in dynamic conditions The cable gland retains IP68 when the cable is exposed to movements. Cable Gland WADI-BN Type 1 – 2 – 3 – 4 – 6 IP68 in Dynamic Conditions This cable gland retains IP68 when the cable is exposed to vibrations Pressing screw anti cable break Pressing Screw Standard WADI-­‐BN Type 6 and Cable Gland ACM NF F 61-­‐030 The cable gland must conform to this standard in order to block a cable in rotation Test In main, with a 50-cm gap from the cable gland: Rotate cable by 360° Maintain for 1 minute In exit Cable does not move (0°) Return to 0° Rotate cable by 360° in opposite direction Maintain for 1 minute In exit Cable does not move (0°) Return to 0° !"#$%#&'()#*+#,+ ! !"# !"#$%&" '()"*#$%&" !"# !"#$%&" '()"*#$%&" !"#$% !"#$ ! Standard cap nut Cap nut with bend protection 3. Functional descriptions Kabelverschraubung WADI-BN Type 1 – 2 – 3 – 4 – 6 IP68 in dynamischen Bedingungen Diese Kabelverschraubung behält IP68 wenn das Kabel Vibrationen ausgesetzt ist Klemmschraube Trichter !"#$%#&'()#*+#,+ ! Cable gland WADI-BN TYPE 1 for terminals Installation instructions 1. Remove seal 2. Press seal together and route terminal through 3. Install seal with cable in the gland Cable gland EMC SCHLEMMER-TEC PROFI Installation instructions By tightening the cap nut the seal exerts pressure on the contact cage inside the clamping element. Thereby the contact ties are gently pressed towards the inside against the cable braiding. The patented 360° connection does not damage the braided shielding of power cables and thus guarantees maximum EMC protection. Shielded cable Cap nut Sealing Lamellar insert Thread body Spring Steel Cage 3. Screw cap nut tight 2. Attach cable gland to cable 1. Strip cable approx. 10-15mm (according to cable gland size) 2.0