JOAP: SIB - General Catalogue - 2020

16 Cable glands WADI-BN TYPE 1 - 6BIS Gradual fixation to the stop In certain cases, it is necessary to fixate the cap nut to the gland element in two steps. 1. Screw the cap nut tight up to the first level. Details of the respective Nm can be found in the test report. 2. Pause for a short intermission of a few seconds. 3. Screw the cap nut even tighter up to the second level (metal on metal). This method allows an intermediate loosening of the seal. As a result, an intensified fixation of the cap nut is made possible. Cable glands WADI-BN TYPE 3 - 6BIS and ACM standard Test instructions: Twist protection according to NF F 61-030 1. Block the wire with help of a bench vice by maintaining a distance of approx. 50cm to the cable gland. 2. Twist the wire 360° and hold it in this position for one minute. It now must not be twisted in front of the opening of the cable gland. 3. Return wire to starting position and loosen the twist (0°). 4. Twist the wire 360° in the opposite direction and hold it in this position for one minute. Also now it must not be twisted in front of the opening of the cable gland. 5. Return wire to starting position and loosen the twist (0°). 2. Twist protection remarks (NF F 61-030) 1. Introduction of the new generation WADI-BN 1. WADI-BN TYPE 3 or 4: • One seal • Standard cap nut or cap nut with bend protection • Fire and heat resistant silicone • Especially cold and frost resistant silicone 2. WADI-BN TYPE 3BIS or 4BIS: • One seal • Standard cap nut or cap nut with bend protection • Cold and frost resistant neoprene 3. WADI-BN TYPE 6: • Two seals • Cap nut with bend protection • Fire and heat resistant silicone • Especially cold and frost resistant silicone 4. WADI-BN TYPE 6BIS: • Two seals • Cap nut with bend protection • Cold and frost resistent neoprene Unattached cap nut Level 1 (standard) Level 2 (to the stop) -360°-Twist, Hold position for 1min +360°-Twist, Hold position for 1min Twist protection (NF F 61-030) Technical Information 2.0