E 1145 - JOAP

Page 9 of 16 When test procedure is completed successfully the drive has been tuned to this specific compressor model. Customer is now able to continue their own testing of entire product / application using either ModBus or connect the 0-10V Signal print and test using a 0-10V signal. In the meantime at LS Control the compressor model and motor will be given a profile number within the software for all future produced SpeedControl 1145s to include this profile making it able to run with this specific compressor model, only by selecting the profile number in the Modbus address or setting the dip-switch on the 0-10V print to the profile number of the specific compressor model. Please note; Any stock of the SpeedControl 1145 delivered prior to the tuning must be returned to LS Control for software update before including the new compressor model or it may be updated by LS Control partner by using a special programmer which may be bought at LS Control. Customer does not have a PC or does not have an internet connection at site If customer doesn´t have a PC or an internet connection at the site where the tuning is to be performed, LS Control will provide a suitcase with all necessary equipment to hook up to LS Control Support. The suitcase with equipment is provided free of charge under the terms that it is returned to LS Control after tuning the drive. Naturally the suitcase will include a detailed description on how to get the PC enclosed online on the internet and ready for LS Control Support to take over. When content of suitcase has been set up the rest of the tuning procedure is as described above under the paragraph ’Getting ready and performing tuning’. The 0-10V Add-on Print with Dip-switch Selection of Profile As already described the SpeedControl 1145 is configured and controlled by ModBus as standard. However an add-on print is available which enables the drive to be configured with any known motor profile by using the dip-switches and furthermore the drive may then be controlled by a 0-10V signal. 0-10 V Add-on Print Choose motor profile using the dip-switch. Mount and click in to the hole above the Modbus terminals Ready for operation Must be chosen before mounting