E 1145 - JOAP

Page 8 of 16 How to Get SpeedControl 1145 Tuned for New Compressor Model / Motor Profile It is important to contact LS Control in case the SpeedControl 1145 is to be used with a compressor model / motor type which is not in the spread sheet. In conjunction it is decided on how to proceed. If a classification B motor profile is to be made it is of most importance a SpeedControl 1145 is delivered in right model and with no tuning and below procedure is followed. Customer has a PC with internet connection at site When there is a PC with internet connection at site LS Control will send an USB-Modbus connector to site (free of chage when returned to LS Control after tuning). When the connector is received and the ’TeamViewer’ program has been downloaded and installed to the PC to be used, an appointment between Technician at site and LS Control Support department is made. The ’TeamViewer’ is located at https://lscontrol.dk/en/about-us/support/ Please click the icon ’LS Control Support’ to install the TeamViewer on the PC to be used to tune the SpeedControl 1145. Getting ready and performing the tuning process Connect the SpeedControl 1145 to the compressor in the product application. Make sure not to connect the power supply, the 0-10V Signal print or any other parts (ModBus translators) must not in any way be connected to the ModBus interface no matter if it should be part of the final application. Then connect the PC to the SpeedControl 1145 using the USB-Modbus connector. Call LS Control Support. LS Control will take over the PC and run a test procedure via the TeamViewer. A customer technician must be available at site during the test procedure to turn on the power supply and to increase and decrease the load on the drive.